Publicité
18
ASSEMBLY
1) Locate a flat, dry area with access to electrical outlet or extension cord.
2) Unroll and place the Rebound™ Bouncer on the ground and locate the valve.
Remove valve cover and push valve plunger in. Twist the valve stem 90 degrees to
open or close the 1-Way valve feature.
3) Using a high output inflator/deflator place the inflation hose with proper adaptor
into the valve. Inflate to 1.2 psi (0,083 bar) where tube is firm and tight. Check for
proper air pressure using a manometer. Inflation times can vary by inflator, but
the tube should be firm and tight when completely inflated. In hot weather, be
sure to leave room for air expansion. DO NOT OVER-FILL. Close the valve and
secure valve cap.
Warning: Do not use an air compressor to inflate tube. Air compressors are
designed for high pressure inflation and can cause tube to burst if over-inflated.
The inflator/deflator described above cannot over-inflate the tube.
4) Roll out your Swimstep™ access platform and connect it to the Rebound™
BEFORE INFLATING the platform using the attached Interloc ™ straps. The access
platform connects on the side of the bouncer where the warnings are located. Find
the 2 rings on the tube, near the water line.
Use (2) Interloc™ straps to connect the access platform to the tube.
Secure the straps according to the following Interloc™ instructions. Once the
straps are connected, then inflate the boarding platform to 0.8 psi (0,055 bar) until
it is firm. Check for proper air pressure using a manometer. This will tighten the
platform to the side of the Rebound™. Be careful not to over-inflate the access
platform.
5) You are now ready to place your Rebound™ in the water.
NOTE: To launch your Rebound™ bouncer, make sure to have at least 3-4 people
evenly spaced around the bouncer to help carry the Rebound™ using the provided
transport handles.
How to connect your Aquaglide Products using the Vario-Lock cinch strap
Publicité
