Parts List - Whale SH2201 Instructions D'installation Et D'utilisation

The Space Heater, its gas supply, and flues for the products of combustion must be inspected in accordance with
national regulations or if these do not exist, the Space Heater manufacturer's recommendations. Whale advises that
this must be carried out at least annually.
Please note: The Space Heater and Ducts will become hot. Avoid anything directly touching the Space
Heater or Ducts.
5. PARTS LIST
The Whale® Space Heater kit contains:
Space Heater and 4 screws
Space Heater and 10 screws
Control Panel / Room Thermostat and 4 screws. Not SC models.
3.5m Control Panel cable (retail only)
Warranty Registration card
Instruction manual including installation templates
Instruction manual storage pocket, with adhesive fixing strip
Please note: The Whale® Space Heater requires a separate Flue Kit for installation.
Exhaust Flues are available in lengths of 1.25 metres and 2 metres.
Inlet Flues are available in lengths of 1.25 metres and 2 metres.
Element Mounting Plate
Electric Assembly
Insulation
PCB
Heat Exchanger Case
Fan Housing Gasket
Motor Mounting Plate
Fan Hot Air
Fan Housing
Air Flow Sensor
Motor Gasket
Element Cover Plate
Fan Combustion Air
Motor
Fig. 1 Components Drawing
SH2201 or
SC2201
Overheat Stat Insulation
Electric Overheat Thermostat
Gas Overheat Thermostat
Heat Exchange Case Cover
Gas Heat Exchange
Heat Exchange Gaskets
Burner Gaskets
Interface Box
Outer Box
4
SH2211 or SH2202 or
SC2211
1
1
1
1
1 1
1 1
1
Burner
Electrodes
Case Lid
Gas Injector
Gas Train
Sealing Washer
End Plate Gasket
End Plate
End Plate
Connector
SC2202
1
1
1
1
1
1
Olive
Nut