Whale SH2201 Instructions D'installation Et D'utilisation page 15

Option 1 - Installing Whale Space Heater Control Panel
Option 2 - Installing Whale Duo Control Panel
Option 3 - Installing Whale iVan Control Panel
Option 4 - Installing Vehicle Manufacturer Control Panel
Option 1 - Installing Whale Space Heater Control Panel
The Whale Space Heater Control Panel requires a cut out 95mm wide x 42mm high. Feed the wires through the cut
out in the wall and locate into desired position. Secure with 4 screws (No.4 x
frame.
In some instances, it may be necessary to make the wiring connections in Step 9, before securing the Control Panel
to the wall.
Please note: It may be possible to retrofit the Whale® Control Panel into existing frames.
Fig. 28 Insert Control Panel
Option 2 - Installing Whale Duo Control Panel
The Whale Duo Control Panel requires a cut out 118mm wide x 64mm high. Feed the wires through the cut out in the
wall and locate into desired position. Secure with 2 screws (No.4 x
In some instances, it may be necessary to make the wiring connections in Step 9 before securing the Whale Duo
Control Panel to the wall.
Option 3 - Installing Whale iVan Control Panel
When installing the Whale iVan ® Control Panel, find a suitable convenient and accessible position.
For good temperature control, select a central position away from draughts, direct sunlight and approximately 1.5
metres above the floor. Ensure suitable access for connecting to the 12V d.c. supply. The minimum panel cut out
depth for the controller and wiring must be 15mm.
i. Position the supplied cutting template in the chosen location and temporarily secure with low tack adhesive.
Using a suitable 10mm drill bit, drill through the template and the panelling behind, in the four corners
marked on the template. Then cut out the rectangular shape by cutting along the dotted lines. Finally, drill the
4 screw holes with a 2mm drill bit. Discard the remains of the cutting template.
ii. Feed the wires through the newly cut hole, and position the controller so that the screw holes line up with
those that have been drilled. Secure in place with the 4 small screws supplied (No.6 × ⅝" pan head screws).
iii. Connect the positive and negative wires from the back of the controller into the vehicle's electrical system
through a 1 Amp automotive fuse.
Please Note: The manufacturer cannot be held responsible for claims arising from incorrect installation, unauthorised
modification or misuse of this product.
Reconnect / turn on the power supply. The Control Panel should turn on. You will be asked to set the time.
Mounting
Frame
Cut Out
Fig. 29 Secure Control Panel
3 ⁄ ") provided, then clip on the surround
4
Surround Frame
Fig. 30 Installed Control Panel
3 ⁄ ") provided, then clip on the Surround Frame.
4