Whale SH2201 Instructions D'installation Et D'utilisation page 14

Important: At least one hot air outlet vent must be permanently open. The hot air duct must not be fed into the
centre branch of a T fitting (see Fig. 25).
Ducting
Hot Air
Hot Air
Fig. 25a Incorrect Tee Fitting Orientation
Step 9 Internal and Underfloor Installation - Fitting Cold Air Supply
The Whale® Space Heater must be adequately supplied with cold air. If the Space Heater is installed in a bed box
or
another confined space, vents into the area must be fitted or ducting used to supply the Space Heater with cold air.
If a vent is fitted, it must be no smaller than one designed for use with 60mm ducting. If ducting is fitted, it must
supply air from the living space of the vehicle. To fit the ducting, push it onto the cold air inlet at the Space Heater
where it will be gripped by the nozzle.
Cold Air Inlet
Cold Air Duct
Fig. 26 Internal Installation - Connect to Cold Air Duct
Step 10 Installing Whale® Control Panel
When installing the Whale® Control Panel, find a suitable convenient and accessible position. For good temperature
control, select a position away from draughts and approximately 1.5 metres above the floor. Ensure suitable access
for wiring loom connection and cable. Note that the cable supplied with the retail Space Heater (models: SH2201,
SH2202, SH2211) to connect the Control Panel to the Space Heater is 3.5m long.
The minimum depth behind panel for wiring must be 40mm. If using a Control Panel specific to the manufacturer of
the vehicle, the electrical connections must be made in accordance with Step 11.
Ducting
Tee Fitting
Hot Air
Ducting
Hot Air Outlet
Hot Air Duct
Ducting
Hot Air
Fig. 25b Correct Tee Fitting Orientation
Hot Air Outlet
14
Hot Air
Ducting
Tee Fitting
Ducting
Hot Air Outlet
Hot Air Duct
Hot Air Outlet
Fig. 27 Underfloor Installation
Vehicle Floor
Cold Air Duct
Cold Air Inlet