Whale SH2201 Instructions D'installation Et D'utilisation page 16

To Set the Time:
• Press and hold the Home Button to enter the 'Setup and Options' screen
• Touch 'Set Clock'
• Adjust the time with the + and - keys, and select to adjust hours or minutes with the left and right arrows.
• Press the 'Home' button to return to the 'Home' screen.
Connecting iVan ® to the Heaters:
Turn on the Water Heater, Space Heater and Control Panel at the same time by using the master switch in the
vehicle. When the Water Heater, Space Heater and Control Panel are switched on (it is important that they turn on at
the same time), within a few seconds "A Water Heater has been found" and "A Space Heater has been found"
message will appear on the screen. Press OK both times and the Water and Space Heater will be paired to the
Control Panel.
Option 4 - Installing Vehicle Manufacturer Control Panel
If your vehicle is fitted with an alternative control panel, please refer to your vehicle manufacturer's handbook or
instructions supplied by the control panel manufacturer.
Step 11 Electrical Connections 12V d.c.
Vehicle Manufacturer Installation
WARNING: Always disconnect the appliance from the power supply prior to working on electrical components.
The Space Heater and both the Whale Space Heater Control Panel and the Whale Duo Control Panel come
complete with electrical connectors fitted.
The Whale® Space Heater and Control Panels are designed to be integrated into the caravan's wiring loom. The
Space Heater is provided with a JST VL series 12 way socket, and the Control Panel with JST VL 6 and 3 way
sockets. 9 wires are required to connect the Space Heater to the Control Panel, and 12V d.c. and 0V d.c. power
supply must be connected to the 12 way socket at the Space Heater.
Please note: Whale recommends that a 5 amp automotive fuse is fitted in the 12V d.c. supply. It may be possible to
retrofit the Whale® Control Panel into existing frames.