Oven Window - Maytag MER5570BCQ Guide De L'utilisateur

MAINTENANCE
OVEN DOOR
CAUTION:
Do not place excessive weight on
or stand on an open oven door.
This could cause the range to tip
over, break the door, or injure the
user.
Do not attempt to open or close
door or operate oven until door is
properly replaced.
Never place fingers between hinge
and front oven frame. Hinge arms
are spring mounted. If accidentally
hit, the hinge will slam shut against
oven frame and could injure your
fingers.
TO REMOVE:
1. When cool, open the oven door to the
broil stop position (opened about four
inches).
2. Grasp door at each side. Do not use
the door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
TO REPLACE:
1. Grasp door at each side.
2. Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge
arms until the door is completely seat-
ed on the hinges. Push down on the
top corners of the door to completely
seat door on hinges. Door should not
appear crooked.
NOTE: The oven door on a new range
may feel "spongy" when it is closed. This
is normal and will decrease with use.

OVEN WINDOW

TO PROTECT THE OVEN
DOOR WINDOW:
1. Do not use abrasive cleaning
agents such as steel wool scour-
ing pads or powdered cleansers
as they may scratch the glass.
2. Do not hit the glass with pots,
pans, furniture, toys or other
objects.
3. Do not close the door until the
oven racks are in place.
Scratching, hitting, jarring or stressing
the glass may weaken its structure
causing an increased risk of breakage
at a later date.
OVEN LIGHT
CAUTION:
Disconnect power to range
before replacing light bulb.
Use a dry potholder to prevent
possible harm to hands when
replacing bulb.
Be sure bulb is cool before
touching bulb.
Do not touch hot bulb with a
damp cloth as this may cause
the bulb to break.
BULB COVER
WIRE
RETAINER
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover
in place, then slide wire retainer off
cover. NOTE: Bulb cover will fall if
not held in place while removing
wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40 watt appliance bulb.
4. Replace bulb cover and secure with
wire retainer.
5. Reconnect power to the range. Re-
set clock.
LEVELING LEGS
CAUTION:
Be sure the anti-tip bracket se-
cures one of the rear leveling legs
to the floor to prevent the range
from accidentally tipping.
The range should be leveled when in-
stalled. If the range is not
level, turn the plastic lev-
eling legs, located at each
corner of the range, until
range is level.
ANTI-TIP BRACKET ANTI-TIP BRACKET
LEVELING LEG
LEVELING LEG
CONVENIENCE OUTLET
(Canadian Models Only)
The convenience outlet is located on
the lower left side of the backguard.
Be sure appliance cords do not rest on
or near the surface element. If the sur-
face element is turned on, the cord and
outlet will be damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the
circuit breaker, press the switch located
on the lower edge of the backguard.
CIRCUIT BREAKER SWITCH
16