Oven Window; Oven Light; Leveling Legs - Maytag MGR5880BDB Guide De L'utilisateur

Maintenance
OVEN DOOR
CAUTION:
➢
Do not place excessive weight on or
stand on an open oven door. This
could cause the range to tip over,
break the door, or injure the user.
➢
Do not attempt to open or close door
or operate oven until door is proper-
ly replaced.
➢
Never place fingers between hinge
and front oven frame. Hinge arms
are spring mounted. If accidentally
hit, the hinge will slam shut against
oven frame and could injure your fin-
gers.
TO REMOVE:
1. When cool, open the oven door to the
first stop position (opened about four
inches).
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
TO REPLACE:
1. Grasp door at each side.
2. Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge arms
until the door is completely seated on
the hinges. Push down on the top cor-
ners of the door to completely seat door
on hinges. Door should not appear
crooked.
NOTE: The oven door on a new range may
feel "spongy" when it is closed. This is nor-
mal and will decrease with use.

OVEN WINDOW

TO PROTECT THE OVEN DOOR WIN-
DOW:
1. Do not use abrasive cleaning agents
such as steel wool scouring pads or
powdered cleansers as they may
scratch the glass.
2. Do not hit the glass with pots, pans, fur-
niture, toys, or other objects.
3. Do not close the oven door until the
oven racks are in place.
Scratching, hitting, jarring or stressing the
glass may weaken its structure causing an
increased risk of breakage at a later date.

LEVELING LEGS

CAUTION:
➢
Be sure the anti-tip bracket secures
one of the rear leveling legs to the
floor. This bracket prevents the
range from accidentally tipping.
The range should be leveled
when installed. If the range is
not level, turn the plastic leveling
legs, located at each corner of
the range, until range is level.
LEVELING LEG

OVEN LIGHT

CAUTION:
➢
Disconnect power to range before
replacing light bulb.
➢
Use a dry potholder to prevent pos-
sible harm to hands when replacing
bulb.
➢
Make sure bulb is cool before touch-
ing bulb.
➢
Do not touch hot bulb with a damp
cloth as this may cause the bulb to
break.
BULB COVER
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover in
place, then slide wire retainer off cover.
NOTE: Bulb cover will fall if not held in
place while removing wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40 watt appliance bulb.
4. Replace bulb cover and secure with
wire retainer.
5. Reconnect power to the range. Reset
ANTI-TIP BRACKET
clock.
WIRE
RETAINER
16