Confirming settings by means of the
Normally closed
In particular, it's possible to select the following time delays:
- 0 (instantaneous changeover)
- ∞ (uninterrupted changeover)
- 1-2-3-5-10-20-30s-1-2-5-10-20-30min (time delay changeover)
Pushing cancel button
saved.
On the contrary, pushing the confirmation button
By pushing for about 5 seconds the "test"
operation of the contact making a changeover test (from normally open to closed or from
normally closed to open).
By pushing for about 5 seconds the "reset"
at steady state (function normally used for long delays).
82
button, the following screen appears:
all changes done about contact mode and delay won't be
Normally open
Time delay
all settings will be applied.
button, it's possible to check the correct
, it's possible to reset the contact status