Measure Menu - LEGRAND MP6 Mode D'emploi

By pushing the "measure"
following page:
"Current"
"Power"
"Harmonics"
"Current" button shows the measured currents for each phase, neutral and earth fault
(if present).
"Voltage" button shows the measured voltage. Line voltages and phase voltages
are shown.
"Power" * button shows the measured power, both three-phases or mono-phase system.
By pushing the "energy" * button it's possible to open the energy sub-menus.
"Harmonics" button allows to display harmonics measures for both currents and voltages.
"Other" button shows the measured frequency (f), three-phase power factor (PF*), and
internal temperature (T) of the protection unit.
* Values shown depends on the current direction (see chapter 7).
64
button in the main menu it's possible to enter the

7. Measure menu

"Voltage"
"Energy"
"Other"