Items Supplied; Proper Use - EINHELL NEW GENERATION NDK 120 L Mode D'emploi

Anleitung NDK 120 L_SPK1:_
Achtung
Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation
nach EN 60825-1: 1994+A2:2001+A1:2002
Laser Klasse 2 RLM-08
P: ≤ 1 mW
Ï: 650 nm
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
1. Layout (Fig. 1)
1 Vacuum extractor unit adapter
2 ON/OFF switch
3 Speed regulator
4 ON/OFF switch for LED light
5 ON/OFF switch for laser
6 Blow-off device
7 LED light
8 Locking screw
9 Scale
10 Pointer
11 Saw blade guard
12 Holding screw
14 Storage compartment for saw blade
14 Sawing table
15 Sawing table insert
14 Clamping lever for saw blade
17 Saw blade holder, top
18 Inspection flap
19 Saw blade holder, bottom
20 Saw blade
21 Laser
22 Adjusting screw for laser
23 Assembly holes
11.12.2006 15:54 Uhr Seite 11
24 Rubber feet

2. Items supplied

Fretsaw
Saw blade guard
Assembly tool

3. Proper use

Assemble the fretsaw as described in Section 7
„Assembly". You are to use this fretsaw only to saw
squared timber or wood-type materials. To cut round
materials you must use suitable holding devices.
The machine is to be used only for its prescribed
purpose.
Any use beyond that mentioned after is considered
to be a case of misuse. The user/operator and not
the manufacturer shall be liable for any damage or
injury resulting from such cases of misuse.
The machine is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off
wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Harmful emissions of wood dust when used in
closed rooms.
Contact with the blade in the uncovered cutting
zone.
Injuries (cuts) when changing the blade.
Crushed fingers.
Kickback.
Tilting of the workpiece due to inadequate
GB
11