Yoo Digital Home i.wip 2000 Notice D'utilisation page 38

U S I N g t h Ro U g h S E t U P o f C L E A N I N g A R E A S
01. Press the [Mode] button to set the [Set cleaning areas] mode.
• When the lamp gets turned on, repeat the pressing until the [Set cleaning areas] lamp is turned
on.
02. Press the [Distance] button and adjust the distance of signals to set cleaning areas.
• Repeat the pressing until the distance of signals to set cleaning areas becomes a desired
level.
• 1m(•) - 3m(••) - 5m(•••)
• If the distance is set as too short or too long, the robot cleaner may decide the area wrongly.
03. Calculate the signal distance to arrange the indicator in an appropriate position.
• If the signal does not reach the wall, the robot cleaner may slip through the crack.
If the emitting signals of each indicator get overlapped, no setup for cleaning area
will be made.
Important
In this case, it will become as if no indicator were installed.
38 USER'S MANUAL I.WIP 2000
Indicator (the pointy part is the front.)
transmission signal (up to 5m)
Robot cleaner
__________________________________________________________
___