Yoo Digital Home i.wip 2000 Notice D'utilisation page 36

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

U S I N g t h E I N D I CAto R ________________________
the indicator enables you to use spaces at home in various forms depending on each zone. Using the
room assortment mode or setting a cleaning area, you can make good use of the indicator.
Check the indicator battery status.
Press any button to check if the lamp blinks; if so, it means the indicator is
normally turned on.
Important
If the battery reaches the end of life, press the button; all the lamps will blink
at the same time. In this case, you need to replace the battery.
If you do not want to use the indicator, turn off the power switch at the rear
part.
U S IN g th E PRo D U Ct f o R thE Ro oM A SS o Rt M EN t M o D E
01. Put the rear of the indicator on the floor at the entrance of a room.
If the indicator is put at a place 10cm or higher than the bottom, the robot cleaner may fail to
identify it.
In general, you can install the indicator at the position marked with the asterisk seen in the
figure below.
Up to five (5) indicators can be installed.
If there is a door at the place with the indicator in it, the door should stay opened as wide as
possible to make the robot work with no restriction.
for other indicators except one provided by default, you need to separately buy them.
Important
02. Press the [Mode] button to set the product in the [Indicator] mode.
When the lamp gets turned on, repeat the pressing until the [Indicator] lamp gets turned on.
03. Press the [Distance] button to set a door width.
1M (•) - 3 m(••) - 5 m (•••).
for common home, 1m setup is available.
36 USER'S MANUAL I.WIP 2000
__________________________________________________________

Publicité

Table des Matières
loading

Table des Matières