Connecting The Pumpset; Single Pumping; Double Pumping - Ardo bellis Mode D'emploi

en
4.3 Preparing the Ardo Bellis breastpump

4.3.1 Connecting the pumpset

Single pumping

Attach the tube connec-
tor to the Ardo Bellis.
The second opening of
the tube connector stays
closed.
The use of the pumpset is described in the enclosed instructions for use "Pumpset and accessories".
4.3.2 Visual inspection before each use
Every time you use the breastpump, check that ...
... the USB cable and power adapter are undamaged.
... the pumpset is clean, correctly assembled, and intact.
... the pumpset is correctly connected.
4.4 Operation and procedure for expressing
Warning: Risk due to contamination / infection
To prevent contamination of your breast milk, thoroughly wash your hands with soap and water before each use.
4.4.1 Basic functions—step-by-step procedure
1
Find a comfortable position for expressing, hold the pumpset on the breast shell, and center the nipple.
2
Press the On/Off button
3 The breastpump is in stimulation mode.
This can be seen by the upper segment of the mode button that lights up orange.
6
to start expressing.

Double pumping

Open the second opening
of the tube connector and
connect the tube of the
second pumpset. Connect
the tube connector to the
Ardo Bellis.