Storage; Disposal - Mettler Toledo InPro 8600i Serie Mode D'emploi

InPro 8600 i Series
InPro 8600 i Series
30 113 529
4.5

Storage

Please inspect the instrument immediately after receiving for eventual transport damages.
The sensor should be stored in a dry, clean and protected area until time of installation.
Storage for a reinstallation
If the sensor has been removed from the process, it should be thoroughly cleaned and dried. It
should be stored in a dry, clean and protected area until time of installation.
Shipment of the sensors
Please clean the instrument carefully before shipment (e.g. for revision / repair). Please use a
fixed packaging to protect the instrument against transport damages. In ideal case the original
packaging should be used.
4.6

Disposal

The disposal is to the responsability of the user. Sensors contain electronic components that
require special disposal without any health hazard for humans, and with no risk of harm for the
environment.
Notice: Please observe the applicable local or national regulations concerning the
disposal of "waste electrical and electronic equipment".
© 07 / 16 Mettler-Toledo GmbH, CH-8902 Urdorf
Printed in Switzerland
23