Remote Control Buttons - Klarstein FROSTIK Mode D'emploi

EN
36
Instructions for the remote control
• This is a universal remote control for air conditioners with multiple functions.
For buttons with functions that the appliance does not have, the appliance
remains in the same state when you press the button.
• Use the remote control to operate the air conditioner while in standby mode.
• When the appliance is switched on, the transmission symbol on the remote
control blinks every time a button is pressed. The air conditioner beeps to
indicate that the signal has been sent.
• When the appliance is switched off, the remote control displays the set
temperature. When the light of the appliance turns on, the corresponding
symbol is displayed.

REMOTE CONTROL BUTTONS

On/Off switch
Press to switch the unit on or off.
Mode
Press to scroll through and select the modes. The corresponding symbol
shown.
• AUTO: In automatic mode, the air conditioner runs automatically depending
on the ambient temperature. The set temperature cannot be changed and is
not displayed. Press the FAN button to set the fan speed.
• COOL: If you select cooling mode, the air conditioner runs in cooling mode
Then press the + and - buttons to set the desired temperature. Press FAN to
set the fan speed.
• DRY: The appliance runs in dehumidification mode at low fan speed You
cannot change the fan speed in dehumidification mode.
• FAN: The appliance runs exclusively in ventilation mode. Press FAN to set the
fan level.
• HEAT: This appliance does not have a heating mode.
is then