Dentsply Sirona inLab Speedcure Manuel D'instructions page 9

GENERAL OPERATION (CONTINUED)
When the unit is turned on, by means of the power switch, a diagnostic test is performed to check the
operation of key systems in the unit. The screen shown below will be displayed. If a problem exists, an error
will be displayed. Reference errors in the Troubleshooting section of this manual.
INITIAL DIAGNOSTICS CHECK SCREEN (DOOR MUST BE CLOSED!)
After a successful diagnostics test the process menu will be displayed.
SELECT PROCESS
Use Cursor Up/Down keys to select process, press PROG.
PROCESS MENU SCREEN
Use the Cursor Up/Down keys to select a process, then press PROG.
6