Dentsply Sirona inLab Speedcure Manuel D'instructions page 10

GENERAL OPERATION (CONTINUED)
Once a process is selected, push the PROG key or the START/STOP key to confirm the Process Parameter
Screen.
PROCESS PARAMETER SCREEN
This screen shows the name of the process selected, the number of lamps used, and its cycle time (excluding
the 3 minutes of cooling time).
To return to the Process Menu press the ESC key or wait 15 seconds, and the screen will automatically return
to the main menu. A timer is displayed at the bottom of the screen indicating how much time is left to start
the process.
To run this process the START/STOP key must be pushed again.
Once started, the process running screen is shown.
PROCESS RUNNING SCREEN
The process will run for the length of the processing time displayed. The unit will pause at the end of process
to check table rotation; a long beep indicates the start of the cooling phase.
7