Power Trim And Tilt Switches (Twin Binnacle Type); Variable Trolling Rpm Switches (If Equipped); Trim Tab With Anode - Yamaha F115 Manuel De L'utilisateur

UP
DN
1. Power trim and tilt switch
EMU26164
Power trim and tilt switches (twin bin-
nacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switches, see
pages 72 and 74.
1
DN
UP
1. Power trim and tilt switch
TIP:
On the dual engine control, the switch on the
remote control grip controls both outboard
motors at the same time.
EMU30903
Variable trolling RPM switches (if
equipped)
The trolling speed can be adjusted when the
1
outboard motor is trolling. Press the "
switch to increase the trolling speed and
press the "
speed.
ZMU08075
" (up) trims the
1. Variable trolling RPM switch
TIP:
 The trolling speed changes approximately
 If the trolling speed has been adjusted, the
 For instructions on using the variable troll-
EMU26246

Trim tab with anode

EWM00841
An improperly adjusted trim tab could
ZMU04601
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
Components
" switch to decrease the trolling
50 r/min each time a switch is pressed.
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
proximately 3000 r/min.
ing RPM switches, see page 70.
WARNING
"
36