Power Trim And Tilt Unit Will Not Operate; Water Separator-Alert Is Activated After Leaving Port - Yamaha F115 Manuel De L'utilisateur

Trouble Recovery
F130, F130A1
3 10 9
9
4
8
7 6
1. Fuse box cover
2. Fuse puller
3. Engine main fuse (50 A)
4. Main switch / trim switch fuse (20 A)
5. Engine control unit / ignition coil / electric
fuel pump / fuel injector / vapor shut-off
valve fuse (20 A)
6. Starter relay fuse (30 A)
7. Electric throttle valve fuse (10 A)
8. Spare fuse (10 A, 20 A, 30 A)
9. Screw
10.Spare engine main fuse (50 A)
4. Install the spare engine main fuse into
the engine main fuse slot, and then tight-
en the screws in their original positions.
5. When replacing a fuse other than the en-
gine main fuse, remove the fuse using
the fuse puller. Install a spare fuse of the
proper amperage.
1
1. Fuse puller
6. Install the fuse box cover.
105
1
2
5 8
ZMU08216
ZMU04337
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40983
Power trim and tilt unit will not oper-
ate
EWM02331
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard mo-
tor can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
3. Tilt the outboard motor up manually to
the desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU44991
Water separator-alert is activated af-
ter leaving port
EWM01501
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
1
ZMU08113