Power Trim And Tilt Will Not Operate; Water Separator-Alert Indicator Blinks While Cruising - Yamaha F150 Mode D'emploi

Trouble Recovery
EMU29526

Power trim and tilt will not operate

If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit, the engine can be tilted man-
ually.
1. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Manual valve screw
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
EMU43533
Water separator-alert indicator blinks
while cruising
EWM01501
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
 Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
 There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
 This procedure will allow some fuel to
spill. Catch fuel in a rag. Wipe up any
spilled fuel immediately.
 The fuel filter must be reassembled
carefully with the O-ring, filter cup, and
hoses in place. Improper assembly or
96
replacement could result in a fuel leak,
which could result in a fire or explosion
hazard.
If the water separator-alert indicator blinks,
perform the following procedure.
1
1. Water separator-alert indicator
1. Stop the engine.
2. Remove the top cowling.
3. Remove the holder.
1
1. Holder
4. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
1
ZMU05442
ZMU05754
[ECM01951]