Operation; Operating Switch; Pressure Regulator And Chemical Product Supply - Dibo ECN-S Mode D'emploi

4. Operation

4.1. Operating switch

The switch has been carried out as a turn button switch with black colour and has two positions:
If the machine has been carried out with a start/stop system, the machine will stop 60 seconds after releasing the
spray gun. Operate the spray gun and the cleaner starts automatically.

4.2. Pressure regulator and chemical product supply

1. Pressure regulator:
The pressure regulator/regulating valve is mounted in front of the cleaner in to the high pressure pump.
On the pressure regulator is a turning button (not always present), where the spray pressure can be adjusted
continuously.
Turning the button to the right: higher pressure (+).
Turning the button to left: lower pressure (-).
The pressure can only be adjusted if the spray gun is operated.
The spray pressure is indicated on the pressure gauge.
2. Chemical product supply:
The chemical product supply is mounted in front of the cleaner, in the neighbourhood of the pressure regulator.
The type of chemical injection is directly integrated on the valve and can be operated by a double spray lance.
This one is not adjustable. Fill the chemicals tank exclusively with permitted products.
Before taking the cleaner into use, check if the used product is arranged to use with the materials of the cleaner.
At doubt get in touch with the salesman of the product or an acknowledged DiBO technician.
ECN-S REV 0
- 0 = OFF
- 1 = ON (in service)
Pressure regulator
Chemical injection
DiBO n.v. 41