Installer Checklist; Final Checklist; To Clean And Protect Exterior Surfaces - Thermador Professional Serie Installation

Installer Checklist

Final Checklist

Rangetop correctly positioned in countertop recess.
Specified clearances maintained to cabinet surfaces.
Burner caps positioned properly on burner bases.
All packaging material removed.
Flush Island Trim or Low Backguard attached
according to instructions.
Gas Supply
Connection: 1/2'' NPT with a minimum 3/4''
diameter flex line.
If converting from natural to LP gas, refer to LP
Conversion Instructions for details.
Manual gas shut off valve installed in an accessible
location (without requiring removal of appliance).
Unit tested and free of gas leaks.
Electrical
A dedicated polarized and grounded 120VAC
receptacle with a 15/ 20 AMP over current
protection is required for cord connection.
Installer
Write the model number and serial numbers (see
figure below) in the Use and Care Guide. Leave the
USE AND CARE GUIDE and INSTALLATION
INSTRUCTIONS with the owner of the appliance.
Operation
Bezels centered on burner knobs, and knobs turn
freely.
Purge air from gas system by operating one of the
burners for several minutes.
Each burner lights satisfactorily, both individually
and with other burners operating.
Burner grates are correctly positioned.

To Clean and Protect Exterior Surfaces

• Always wipe in the direction of the stainless steel
grain.
• To condition and protect stainless steel, use the
Thermador Stainless Steel Conditioner, which can be
purchased in the Thermador eShop
(store.thermador.com/us).
• DO NOT allow deposits to remain for long periods of
time.
• DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface causing
rust.
• DO NOT allow salt solutions, disinfectants, bleaches
or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these
compounds contain chemicals which could prove
harmful. Rinse with water after exposure and wipe dry
with a clean cloth.
Troubleshooting
See Use and Care Guide for troubleshooting information.
Page. 18