Use & Maintenance; Unfolding And Folding Base Frame - Zippie VOYAGE Manuel D'instructions

Masquer les pouces Voir aussi pour VOYAGE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Z IPP IE VO YA GE
E. UNFOLDING AND FOLDING BASE FRAME
Zippie dependent mobility devices are designed for stability and performance. When unfold-
ed, the device must be fully open and locked to avoid injury to the dependent rider. Follow
the instructions for unfolding the device carefully, and double-check that the device is fully
locked before adding the seating shell and rider.
5
6
7
Unfolding:
a. Unsnap the storage lock (A) from around the folded frame. It should remain attached
to the frame for future use.
b. Pull the top and bottom of the frame in opposite directions to open the frame and
upholstery.
c. Set the Frame and upholstery down on a flat surface, and push down on pivot point
(B) until there is an audible "click" to lock the frame.
d. Rear wheels and front casters can now be attached if they are not attached already.
5
6
8
Folding:
The Voyage is not intended to be folded with the seating system installed. ALWAYS remove the seat-
ing system prior to folding the base. Failure to do this may damage the product.
a. Remove the child from the seating shell, then remove the seating shell (refer to sub-
section ( J )
b. Pull up on both fold handles (C) at the same time with a gentle tug. This action will
release the frame lock. Continue pulling up on the fold handles until the frame is fully
collapsed. It may be necessary to push the handle and caster ends of the frame
together with light pressure.
c. Snap the storage lock (A) around the upper frame to prevent the frame from opening
when transporting, or storing the frame.
d. If required, use the additional folding strap that has been provided with the stroller.
NOTE - Rear wheels, or front casters do not have to be removed for this procedure, but may be
removed to save space for storage. If you decide to leave the front casters on the device, it
may not lock correctly due to interference between the caster wheels and the push handle. In
most cases you should fully retract the push handle before folding, then you will be able to
snap the storage lock easily.
Do not force the base open or closed if it sticks during unfolding or folding, damage could
occur.
MK-100377 Rev. A
WARNING
WARNING
12
VIII. USE AND MAINTENANCE
5
6
7
8

Publicité

Table des Matières
loading

Table des Matières