Preliminary Check - LEMI TESERA 1-3-4M Notice D'utilisation

WARNING! It is strongly recommended to insert the plug into a single outlet exclusively reser-
ved to the device. We do not recommend the use of multiple sockets (power strip), adopters
and patch cords. The cable must not be bent.
WARNING! Before plugging in the cable, make sure that it is not twisted or bended and make
sure that the protective sheath is undamaged.
WARNING! The chair must be positioned in order to ease the removal of the electric plug.
WARNING! To avoid the risk of electrical shock, this chair must exclusively be plugged in power
supply grids with protective ground.
2.8. Instructions to replace fuse
To replace fuses, open the small part on the panel board with the symbol
3. ENVIRONMENTAL WORKING CONDITIONS AND STORAGE
The chair has been designed and built to operate in a closed and dry room. The ambient operating condition are:
• temperature: 5° ÷ 40° C
• humidity: 30% ÷ 75% without condensation.
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate air condi-
tioning system to bring the humidity and temperature values within acceptable limits.
WARNING! Do not expose the chair to an excessively humid environment. If the chair gets wet, re-
move the plug from the outlet and have it checked by an Authorized Service Centre.
WARNING! The chair was not designed to work in environments with explosive atmospheres, in the
presence of fine dust or corrosive gases, in the presence of acids, corrosive agents, salt. It is also not
suitable for operation in the presence of ionizing and non-ionizing radiation (X-rays, laser, microwa-
ves, ultraviolet rays). Not intended for use with flammable anaesthetics or in conjunction with flam-
mable agents.
STORAGE! For the correct functioning of the electrical equipment the storage of the chair must be
at a temperature between -25° C and +55° C, and only for short periods not exceeding 24 hours, to
+70°C. The chair has no special requirements for storage, provided that it takes place in a closed and
dry rooms; this condition should also be ensured during all phases of transport.
Before the setting at work of the chair, make sure that:
There is no damage to the equipment due to the phases of transport and handling; eventually proceed to solve
these problems by contacting Brusaferri & C.;
All packaging components have been removed;
Check that the supply voltage is equal to the rated one as defined in § 2.6. Power Supply;
Check the efficiency of the operation of the control equipment.
Before using the chair for the first time, make sure qualified personnel carry out some tests in safety conditions.
%

4. PRELIMINARY CHECK

7