Preliminary Check - LEMI BELLAGIO 1M Notice D'utilisation

2.6. Connections
Insert the plug into a suitable power outlet.
If there is incompatibility between the socket and the plug of the table, replace the socket with
a suitable type by professionally qualified personnel.
PULL THE PLUG FROM THE POWER OUTLET GRASPING THE PLUG, NOT THE CABLE.
WARNING! It is strongly recommended to insert the plug into a single outlet exclusively reserved
to the device. We do not recommend the use of multiple sockets (power strip), adopters and patch
cords. The cable must not be bent.
3. ENVIRONMENTAL WORKING
CONDITIONS AND STORAGE
The table has been designed and built to operate in a closed and dry room. The ambient operating condition are:
Temperature: 5° ÷ 40° C
Humidity: 30% ÷ 95% without condensation
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate air condi-
tioning system to bring the humidity and temperature values within acceptable limits.
WARNING! The table was not designed to work in environments with explosive atmospheres, in the
presence of fine dust or corrosive gases, in the presence of acids, corrosive agents, salt; it is also not
suitable for operation in the presence of ionizing and non-ionizing radiation (X-rays, laser, microwa-
ves, ultraviolet rays).
WARNING! Do not expose the table to an excessively humid environment. If the table gets wet, re-
move the plug from the outlet and have it checked by an Authorized Service Centre.
STORAGE! For the correct functioning of the electrical equipment the storage of the table must be
at a temperature between -25° C and +55° C, and only for short periods not exceeding 24 hours, to
+70°C. The table has no special requirements for storage, provided that it takes place in a closed and
dry rooms; this condition should also be ensured during all phases of transport.

4. PRELIMINARY CHECK

Before the setting at work of the table, make sure that:
There is no damage to the equipment due to the phases of transport and handling; eventually proceed to solve
these problems by contacting Brusaferri & C.;
All packaging components have been removed;
Check that the supply voltage is equal to the rated one as defined in § 2.5. Power Supply;
Check the efficiency of the operation of the control equipment.
Before using the table for the first time, make sure qualified personnel carry out some tests in safety conditions.
6