LEMI TESERA 1-3-4M Notice D'utilisation page 9

WARNING! These armrest were only meant to support the arm. It is strictly forbidden to
seat on the armrests. Any damage caused by improper use, would not be considered under
warranty.
6.5. Rollholder
The chair can be equipped with a roll holder, which is installed by using specific strings fixed to two screws
on the backrest.
6.6. Medical accessories
Accessory
Thight Support
Heel Support
Feet Support
Medical Armrests
Blood taking armrests
Curtain holder
I.V. Rod
Inox Metal Tray
You must insert the accessories in the slots of the clamps and fix to the guides by screwing and unscrewing
the handle. As for the blood-sample taking armrests, the thigh supports and the metal tray, once they are
properly installed it is possible to turn the handles without loosening the clamps; simply pull the handles and
place them so that they do not bother while using the chair.
6.7. Heating
The heating system of the mattress can be regulated by the HEAT button panel, which is on the backrest.
Button 1: regulation of the lowest temperature (40° C).
Button 1+2: regulation of the highest temperature (42° C)
Lightened Red Led: Heating is ON
Always turn off the heating when you do not use the chair!
6.8. Wheels
You can install the braked wheels on the chair by unscrewing the 4 fixed feet.
Always block the brake of each wheel before the client sit on the chair.
6.9. Chair Rotation
The upper part of the chair can rotate to 180° (90° left + 90° right). To
rotate the chair, turn the handle situated under the basement, fix the
chair into the required position and block the rotation by tightening the
handle clockwise.
Position of the guides
On the seat
On the seat
On the seat
On the back
On the seat
On the back
On the back
On the seat
Clamps to use to fix the accessory
Fixed
Fixed
Fixed
Rotatable
Fixed
Rotatable
Rotatable
Fixed
9