Operating The Device - Axion STIM-PRO X9a Manuel D'utilisation

AXION

OPERATING THE DEVICE

Power On/Off button and intensity control
EN
The device can be switched on and off by pressing the On/
Off button. The intensity can be reduced or increased by
pressing the intensity buttons. The intensity can be set per
channel from 0 to 100mA in steps of 1mA.
There are 4 LED lights at the top of the device. They shine
yellow to indicate activity of the corresponding channel.
Mode control
There are 5 TENS modes available (B,
N, M, SD1, SD2) and 3 EMS modes (C,
S, A) as well as the P mode (programs
1-37). The modes can be selected
by pressing the "MODE" button. If a
TENS mode is selected, the LCD-dis-
play shows "TENS". If an EMS mode is
selected, "EMS" is displayed.
Set control
By pressing the control, you may enter the setting
you intend to make adjustment. You may start to set the
value by pressing the or controls when the value is
flashing.
Increment control
When pressing this button, the parameter will increase. This
button controls the increase of settings.
Decrement control
When pressing this button, the parameter will decrease.
This button controls the decrease of parameter.
38