Aquaglide QUARTERBACK Manuel Du Propriétaire page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position
will also make launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note
original folding & packaging method. Remove valve cap and confirm valve is in inflate (1-way
airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use
pump to inflate Main Valve [1] to Working Pressure as shown in Chart 1. Check for proper
pressure using gauge (manometer). Replace valve cap.
4. Repeat step 3 instructions to inflate each chamber to proper Working Pressure shown in
Chart 1 until all chambers are properly inflated.
5. Confirm that suitable anchor(s) and mooring lines are in place before launching this item
(see Anchoring).
6. To launch product, lift completely and place in water. Large items may require many extra
people to accomplish this. Never drag product as damage may occur.
7. When connecting multiple items together, always follow manufacturer's
recommendations. Use only Aquaglide Two-Step Vario-lock cinch straps and connecting
rings. Make sure connection is tight and there is NO GAP between items. Failure to connect
items properly may result in injury or death. See D1 - D6.
a. Attach straps to 'Connectors' (example: Solarium, Swimstep, Splashmat, Speedway,
Breezeway or Deck) where a connection is required. Connectors should not be attached
to other connectors.
b. Use all available rings to make connection. Standard connections use 5 rings. Some
items use 3 or occasionally 7 rings/ straps. Quarterback is a feature item with 5-ring sets
on 2 ends and 1 side (outer corner).
c. Float 'Connector' into desired position. Note: a matching set of connecting rings is
required on feature item.
d. Attach center strap to center ring on feature item. Connect loosely, then work outward
until all straps are connected.
e. Dive beneath to tighten all straps securely. Dive mask and several attempts may be
required.
D-1
D-4
7
D-2
D-5
D-3
D-6
www.aquaglide.com

Publicité

Table des Matières
loading

Table des Matières