Aircare 831000 Manuel D'utilisation Et D'entretien page 4

NOTES ON LOCATION:
In order to get the most effective use from your
humidifier, it is important to position the unit
where the most humidity is needed or where the
moist air will be circulated throughout the house
such as near a cold air return. If the unit is
positioned close to a window, condensation may
form on the window pane. If this occurs the unit
should be repositioned in another location.
Do NOT position the unit directly in front of a hot
air duct or radiator. Do NOT place on soft carpet.
Due to release of cool, moist air from the humidifier, it is best to direct air away
from thermostat and hot air registers. Ensure free air flow around humidistat.
Position humidifier next to an inside wall on a level place at least 4 inches
away from the wall or curtains.
ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging materials. Check to see that you have all of the
following items removed from the box, accessory kit and cabinet before
discarding the packaging:

Evaporative wick and wick retainer

Lift rod assembly with Styrofoam float
CASTERS
3) Turn the emptied cabinet upside down. Insert each caster stem into one
of the four caster holes on the corner of the humidifier bottom. The
casters should fit snugly and be inserted until the stem shoulder reaches
the cabinet surface.
4) Turn the cabinet right side up.
FLOAT AND EVAPORATIVE WICK INSTALLATION
5) Place the float assembly and attached lift
rod into the boxed area on the bottom of
the inside of the cabinet. Slip lift rod into
retainer ring and twist to secure. The lift rod
should be able to freely move up and down
about 3/8". The retainer ring should be
located between the two ribs on the lift rod.
6) Place the wick assembly into the guides
provided in the bottom of the cabinet and
the ribs along the sides.
7) Place the chassis unit onto the cabinet
ensuring that the chassis seats correctly
into the front and back grooved edges.
HUMIDISTAT

Caster kit

Manual
Lift Rod
Wick & Retainer
4
Styrofoam Float
Retainer
fits into box
Ring
molded into
reservoir floor