Troubleshooting - ECOVACS ROBOTICS DEEBOT 605 Manuel D'instructions

No. Malfunction
1 DEEBOT is not charging.
DEEBOT cannot return to the
2
Docking Station.
DEEBOT gets stuck while
3
working and stops.
DEEBOT returns to the Docking
4 Station before it has finished
cleaning
Possible Causes
DEEBOT is not switched ON.
DEEBOT has not connected to the Docking
Station.
The battery is completely discharged.
The Docking Station is not correctly placed.
DEEBOT is tangled with something on the floor
(electrical wires, curtains, carpet fringing, etc.).
When the battery gets low, DEEBOT
automatically switches to Return to Charger
Mode and returns to the Docking Station to
recharge itself.
Working time varies according to floor
surface, room complexity and the Cleaning
Mode selected.

6. Troubleshooting

Solutions
Switch ON DEEBOT.
Be sure that the robot's Charging Contacts have
connected to the Docking Station Pins.
Re-activate the battery. Switch ON DEEBOT. Place
DEEBOT on the Docking Station by hand, remove after
charging for 3 minutes, repeat 3 times; then charge
normally.
Refer to Section 3.2 to correctly place the Docking
Station.
DEEBOT will try various ways to free itself. If it is
unsuccessful, manually remove the obstacles and restart.
This is normal. No solution necessary.
This is normal. No solution necessary.
23
EN