Troubleshooting - ECOVACS ROBOTICS DEEBOT M88 Manuel D'instructions

Please use this chart to troubleshoot common problems using DEEBOT.
No. Malfunction
DEEBOT will not
1
charge.
DEEBOT will not
2 return to the Charging
Dock.
DEEBOT gets into
3 trouble while working
and stops.
Possible Causes
DEEBOT is not powered
ON.
DEEBOT has not made a
connection with the Charging
Dock.
The Charging Dock is
unplugged while DEEBOT is
powered ON, which causes
battery consumption.
The battery is completely
discharged.
The Charging Dock is placed
incorrectly.
DEEBOT is tangled with
something on the floor
(electrical cords, drooping
curtains, area rug fringe
etc.).
The Side Brushes are
tangled with hair or debris,
and low rotation speed
causes DEEBOT to Pause
and triggers an alarm.
The Main Brush is stuck,
and low rotation speed
causes DEEBOT to Pause
and triggers an alarm.

5. Troubleshooting

Solutions
Move the robot's Bottom Power Switch
to the ON position.
Be sure that the robot's Charging
Contacts have made a connection
with the Charging Dock Pins. You may
move the robot manually to make the
connection if necessary.
Plug in the Charging Dock and ensure
DEEBOT is powered ON. Keep
DEEBOT on the Charging Dock to
make sure it has full battery to work at
any time.
Re-activate the battery.
Please refer to section 3.2 Quick Start
for details on proper Charging Dock
placement.
DEEBOT will try various ways
to get itself out of trouble. If it is
unsuccessful, manually remove the
obstacles and restart.
Check Side Brushes for tangled hair or
debris, clean as described in section 4
Maintenance and restart. If the Side
Brushes still rotate slowly, please
contact Customer Service.
Remove the Main Brush Cover and
remove the Main Brush. Clean any
tangled hair or debris on the Main
Brush as described in section 4
Maintenance and restart. If DEEBOT
does not function normally, replace the
Main Brush.
27
EN