ECOVACS ROBOTICS DEEBOT M88 Manuel D'instructions page 31

No. Malfunction
Remote Control failure
(Effective control
7
change of the Remote
Control is 5m (16').
Possible Causes
The battery in the Remote
Control need to be replaced.
DEEBOT is powered OFF or
the robot's battery is low.
The infrared signal cannot
be transmitted because the
Infrared Emitter on Remote
Control or the Infrared
Receiver on DEEBOT is
dirty.
There is other equipment
interfering with the infrared
signal to DEEBOT.
5. Troubleshooting
Solutions
Replace with a new battery making
sure it is installed correctly.
Make sure DEEBOT is powered ON
and fully charged.
Use clean dry cloth or the brush
side of the provided Multi-Function
Cleaning Tool to wipe the Infrared
Emitter on Remote Control and the
Infrared Receiver on DEEBOT.
Avoid using the Remote Control near
other equipment using infrared signals.
29
EN