Troubleshooting; Fault Causes And Remedies - SilverCrest SKR 800 B2 Mode D'emploi Et Consignes De Sécurité

Troubleshooting

This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.

Fault causes and remedies

The following table will help you to identify and rectify minor malfunctions:
Fault
The display
indicates nothing.
No sound.
Static noise in the
radio reception.
The time and
station presets are
lost after a power
failure.
No automatic time
setting.
NOTE
► If the above-mentioned solutions do not resolve the problem, please contact
Customer Service (see section "Service").
■ 40 │ GB │ IE
Possible cause
The plug is not connected.
The mains socket is not
supplying power.
The display is switched off
automatically or manually.
The volume is set to mini-
mum.
The device is in clock/
standby mode.
The reception is weak.
No batteries in the battery
compartment or batteries
are dead.
The RDS signal is too weak.
Remedy
Insert the power plug into the socket.
Check the house mains fuse.
Press any button on the device.
Increase the volume with the
−VOLUME+ | ON/OFF
Press the −VOLUME+ | ON/OFF dial
to switch on the radio mode.
Try to improve reception by moving the
wire aerial .
Press and hold the
button for about 2 seconds to
switch the station to mono.
Check that the batteries have sufficient
voltage and replace them if necessary.
The time and station presets will need
to be reprogrammed.
The time must be set manually.
dial.
| ST/MO
SKR 800 B2