Deleting The Pairing Of Bluetooth Devices - Unitron uStream Guide

Selecting from multiple inputs using the
uStream
With only one audio source (e.g., from a
Bluetooth transmitter), each press of the access
( ) button will pause or resume the audio
source. You can completely stop the music by
pressing and holding the access ( ) button for
two seconds. It must be re-started using the
music device.
Multiple sound sources can be accessed
sequentially by pressing the access ( ) button.
After each press, the uStream selects the next
connected source in a fixed sequence.
If a source is not connected, the uStream will
skip over it and proceed to the next source.
Every connected audio source has a fixed place
in the sequence, as shown in the diagram.
Previously-active
hearing program
Bluetooth Bluetooth
music 2 music 1
38
Deleting the pairing of Bluetooth
devices
If you encounter issues with one of the paired
devices, or if a device stops connecting to your
uStream, you may consider deleting the pairing
of devices to the uStream.
1. Turn on your uStream while pressing the
volume up ( ) button.
2. Release the volume up ( ) button only after
ten seconds when the rapidly blue blinking
indicator light turns green.
3. Also delete the uStream pairing entries on
your mobile phone before any re-pairing.
4. Repeat the pairing procedure.

Deleting the pairing of Bluetooth devices

removes the ability to connect to these devices.
You will need to perform the pairing process
again if you wish to reconnect.
39