Control Knobs - Thermador MASTERPIECE Serie Guide D'utilisation Et D'entretien

36" SGSXP
WARNING
9
To prevent flare-ups, properly support pots and
avoid spills, all grates must be properly positioned
on the cooktop whenever the cooktop is in use.
Each of the four feet must be placed into the
corresponding dimples in the cooktop. Do not use a
grate if the rubber feet are missing or damaged.
For replacement of rubber feet: Call Customer Support
at 1-800-735-4328.

Control Knobs

The cooktop has one control knob for each burner. Push
down and turn to the left to light and set the desired heat
setting.
WARNING
9
Failure to operate knobs properly may result in
personal injury and damage to the appliance.
Standard Knobs
SGS and SGSP models, which do not feature ExtraLow
operation, have only standard metal burner controls and
rubber grommets.
To operate: Select the appropriate control knob and push
down. A clicking noise will occur immediately after
pushing the knob. Turn knob counterclockwise to the HI
setting to ignite the flame. Continue turning knob
counterclockwise to desired flame size. Turn off by
turning the control knob clockwise to OFF.
ExtraLow (XLO) Knobs
®
SGSX and SGSXP models have standard metal burner
controls and rubber grommets as well as two ExtraLow
burner controls on the left front and center.
~ "Thermador ExtraLow
and SGSXP models only)" on page 12
The ExtraLow® burner controls have five XLO settings
that vary in heating level. A slight catch will be felt when
at the LO position and each designated XLO setting.
To operate: Select the appropriate control knob, push
down and turn counterclockwise until the control knob is
set within one of the five XLO settings. Turn off by turning
the control knob clockwise to OFF.
Control Knob Removal
To remove knob and/or grommet: With control knob in
the OFF position, gently lift knob up and off. Gently pull
the grommet from the sides and lift out.
WARNING
9
To avoid possible electric shock, do not reach
through control opening into rough-in box.
WARNING
9
Do not use the appliance without the knobs and
grommets in place.
®
To replace knob and/or grommet: Carefully insert the
grommet into the opening, ensuring that the maintop is
seated in the track around the entire perimeter of the
grommet. Replace control knob by placing indicator line
at the OFF position. Press down firmly.
(XLO) STAR™ Burners (SGSX
®
®
13