Installing The Handles - Bosch B21CT80SNS Notice D'utilisation Et De Montage

Electrical connection
WARNING
Risk of electric shock and fire if electrical
connection is not installed properly!
Plug into a fixed, grounded 3-prong outlet only. The
outlet must be installed and grounded according to
code by a qualified electrician. If necessary, have
the installation inspected by a qualified electrician
to ensure it is properly grounded.
Never remove grounding conductor.
Do not use an extension cord, adapters or power
strip.
Non-compliance with these instructions may result
in death, fire or an electric shock. Improper
connection of the grounding conductor may result
in an electric shock. If you are in doubt whether the
appliance has been grounded properly, have the
appliance tested by a qualified electrician.
The receptacle must be installed according to the
Installation Manual.
Connect the appliance to 115 V/60 Hz AC through a
correctly installed 3-pole grounded receptacle. The
receptacle must be protected with a 15 to 20 A fuse.
The appliance comes with a UL registered 3-wire
Power Cord.
Please see the following table:
Appliance Maximum simultaneous load
Fridge-freezer 6.0 amps
Check on the Rating Plate whether the indicated
voltage and current type correspond with the values of
your power supply. The location of the Rating Plate
can be found in the chapter "Customer Service".
WARNING
Never connect the appliance to electronic energy
saving devices.
This appliance can be used with power line and
sine-controlled inverters. Power line-controlled
inverters are used for photovoltaic systems which
are connected directly to the national grid.
Sine-controlled inverters must be used for isolated
applications (e.g. on ships or in mountain lodges)
which are not connected directly to the national
grid.

Installing the handles

NOTICE
Please remove protective film BEFORE installing
handles.
Difference between the freezer and the
refrigerator door handle
Handles are located inside of the carton box.
31.6˝ (803.8 mm)
Refrigerator door handle
2.1˝
(54 mm)
31.6˝ (802.3 mm)
Freezer door handle
2.1˝
(54 mm)
Refrigerator door handle
1. Take the refrigerator door handle out of the box
and place it as per the direction shown in the figure
(Note: i.e. the direction which both screw holes on
the handle are close to the edge) and hang the
handle above the set bolt.
2. Use the small hexagon wrench supplied in the box
to set the handle screws into both the small
screwed holes on the handle. After they are
screwed down, gently shake the handle to confirm
the handle is tightened.
Inner socket head cap
screw for handle fixing
Refrigerator
door handle
Inner socket head cap
screw for handle fixing
Freezer door handle
The assembly steps of the freezer door handle are the
same as the ones of the refrigerator door handle.
During the assembly of the handle the direction of
tapping hole is downward (towards the ground).
en-us
Bolt
Bolt
9