Water Connection - Bosch B21CT80SNS Notice D'utilisation Et De Montage

en-us

Water connection

WARNING
Risk of electric shock and damage to the appliance!
Disconnect the appliance from the power source
before performing any work on the water
connection.
Only a qualified installation technician may connect
the appliance to the water supply in accordance
with plumbing and relevant water utility company
regulations.
Connect the appliance to a drinking water line only:
Minimum pressure:
n
0.17 MPa (1.72 bar, 24.95 PSI)
Maximum pressure:
n
0.82 MPa (8.25 bar, 119.66 PSI)
n Pressure over 0.82 MPa (8.25 bar, 119.66 PSI):
install a pressure limiter between drinking water
connection and hose set.
The water should be connected only by a competent
plumber according to the local regulations of the
appropriate Water Supply company.
A cold water connection is necessary for operating the
ice maker. The water pressure must be between
0.17 MPa (1.72 bar, 24.95 PSI) and
0.82 MPa (8.25 bar, 119.66 PSI). The installation must
correspond to the local plumbing regulations.
A separate Shut-Off-Valve should be installed in the
cold-water inflow.
It is recommended that you mount the Shut-Off-Valve
directly next to the appliance or at another place that
is easily accessible.
When installing the water connection, pay attention to
the permissible installation area for the water line.
For connection to the drinking water line use only
water pipes that are suitable for drinking water.
Observe national regulations and the connection
conditions of the local Water Supply companies.
8
NOTICE
As the photo shows, there's a water filter fixed and
located inside the EPS put in the cavity of the
refrigerator compartment. Please kindly note.
Water filter