Electrical Installation - Dometic ROLLERBLIND POWERED Instructions De Montage Et De Service

Installation
➤ Proceed as shown:
– BR leaflet:
BR 38/46: fig. 2 to fig. 4
BR 55: fig. 5 to fig. 7
– MP leaflet: fig. 2 to fig. 3
– CA leaflet: fig. 2 to fig. 3
➤ Proceed as shown to remove the blinds:
– BR leaflet:
BR 38/46: fig. 8
BR 55: fig. 9
– MP leaflet: fig. 4
– CA leaflet: fig. 4
7.6 Fitting the guide wire versions
➤ Proceed as shown:
– BR leaflet: fig. 0 to fig. c
– MP leaflet: fig. 5 to fig. 9
– CA leaflet: fig. 5 to fig. 0
➤ Fix the hold down according the chosen option:
– Dome mounted hold down (A) (BR leaflet: fig. a, MP leaflet: fig. 7,
CA leaflet: fig. 7)
– Flush mounted hold down (B) (BR leaflet: fig. b, MP leaflet: fig. 8,
CA leaflet: fig. 8)
– Extended guide wire hold down (C) (BR leaflet: fig. c, MP leaflet: fig. 9,
CA leaflet: fig. 9)
7.7 Fitting the side track versions
➤ Proceed as shown:
– BR leaflet: fig. d to fig. e
– MP leaflet: fig. 0 to fig. a
– CA leaflet: fig. 0 to fig. a
7.8

Electrical installation

Proceed as follows:
1. Check the voltage of the blind (see cable label).
2. Decide on the routing of the motor wire.
3. Choose a location for the control device.
10
Rollerblind Powered
EN