Burner "On" Light; Burner Grates - Thermador SGS Serie Manuel D'utilisation

Thermador® ExtraLow
Burners
(SGSX Models only)

Burner "ON" Light

Burner Grates

English 6
WARNING:
cooktop without all burner caps and all burner grates properly posi-
tioned.
Two burners are enhanced with the ExtraLow (XLO®) feature. When the control
knob is set within the XLO® zone, the flame cycles OFF and ON automatically for
varying seconds every minute. This cycling is normal and allows you to simmer,
poach, melt or hold cooked food without scorching or burning.
How They Work
• The burner flame will cycle ON and OFF each minute when the setting is at
any position between LO (past detent) and XLO.
• The length of time the flame is ON and OFF depends on the knob setting.
• With a setting just below LO, the flame will be ON approximately 53 seconds
and OFF 7 seconds of each minute.
• With a setting at the XLO position, the flame is ON approximately 7 seconds
and OFF 53 seconds of each minute.
• The knob can be set to any position between LO and XLO.
WARNING:
both XLO burners are in use. When the XLO burner automatically reig-
nites, the igniter at the burner will spark.
The "ON" light is located in the center of the burner control knobs for the 30"
(76cm) and 45" (114cm) models. On the 36" (91cm) model it is to the left of the
control knobs. When illuminated, it indicates that one or more burners are in use.
It remains on until all burners are turned off.
Grates must be properly positioned before cooking.
LEFT
45" LEFT
30" (76cm) Models have two universal grates and a center grate. Position the
short side of the grates toward the center and place the curved part of the grate
bridge at the front. The grates are not interchangeable.
To avoid creation of harmful by products, do not use the
Do not clean or touch any of the burners when one or
RIGHT
UNIVERSAL
CENTER
(ALL MODELS)
(ONLY 36" MODELS )
45" RIGHT
CENTER
(ONLY 45" MODELS)
CENTER
(ONLY 30" MODELS)
Burner Grates
Figure 5: