Publicité
Part number
Tool name/How to use
This tool is used for when loosening or tightening the
flywheel magneto securing nut.
Use this tool to inspect the coil resistance, output
voltage and amperage.
This tool is necessary for checking ignition timing.
This tool is needed to remove and install the valve
assemblies.
This tool is used to hold the clutch when removing or
installing the clutch boss securing nut.
Intake 4.0 mm (0.16 in)
Exhaust 4.5 mm (0.18 in)
This tool is needed to remove and install the valve
guide.
Intake 4.0 mm (0.16 in)
Exhaust 4.5 mm (0.18 in)
This tool is needed to install the valve guide.
Intake 4.0 mm (0.16 in)
Exhaust 4.5 mm (0.18 in)
This tool is needed to rebore the new valve guide.
This tool is used to remove the flywheel magneto.
SPECIAL TOOLS
1 - 12
GEN
INFO
Illustration
Publicité
Chapitres
