Publicité
Ê Fasten the diode (at the white tape), rectifier/regulator lead,
CDI unit lead (at the protecting tube) and AC magneto coupler
(connected to the CDI unit).
Ë Fasten the wire harness, starter motor lead and negative bat-
tery lead so that the plastic locking tie ends do not contact the
ignition coil lead.
Ì Fasten the wire harness, rectifier/regulator lead, coolant reser-
voir hose, hot starter cable, negative battery lead and starter
motor lead.
Í Fasten the wire harness, negative battery lead, starter motor
lead, rectifier/regulator lead and coolant reservoir hose at the
white tape for the negative battery lead.
Î Fasten the wire harness at its white tape.
Û F
0
I
B-B
0
Ü 3
Ù F
Ú
H
G
Ù F
D
E
9
Ø C
× B
Ö 3
8
Ô 0
Õ 3
CABLE ROUTING DIAGRAM
Ï Fasten the wire harness, throttle position sensor lead (in the
wire harness), starter motor lead and negative battery lead.
Ð Make sure that the throttle position sensor coupler does not go
outside the chassis.
Ñ Fasten the throttle position sensor lead.
Ò Pass the carburetor breather hoses, carburetor overflow hose
and coolant reservoir breather hose between the connecting
rod and cross tube (frame).
Ó Fasten the neutral switch lead and oil hose together with the
plastic locking ties and cut off the tie ends.
Ô Pass the cylinder head breather hose through the hose guides.
Õ Fasten the neutral switch lead.
1 È
2 É
J
3 Ê
4 3 Ë
3 Ì 5
6
B
B
A
3 Ó
0 Ô
2 - 99
SPEC
L
J
K
A
3 Í
3 Ï
3 Î
Ð
A
8
9
Ý
3 Ñ
7
Ò
Publicité
Chapitres
