Ordering Replacement Parts - EINHELL HSP 6/104 Mode D'emploi

Anleitung HSP_6-104_SPK1:Anleitung HSP41-1_HSP51_SPK1

14. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
15. Troubleshooting
The following table describes the possible problems which may arise when you use the wood splitter and
provides recommended remedial measures for dealing with them.
Problem
Motor fails to start Motor circuit breaker has been
triggered
Trunk fails to split Trunk is incorrectly positioned
Trunk exceeds permitted
dimensions
Wedge fails to cut
Oil leak
Pressure setting screw has been
displaced
The trunk pusher moves jerkily or Air in the oil circuit
with excessive vibrations
Escaping oil from the cylinder or Ventilation screw not unscrewed
other point. during operation.
Ventilation screw not screwed tight
during transportation
Oil drainage screw not screwed
tight
Oil seal is worn
Probable cause Remedy
Allow the motor to cool down and
press in the motor circuit breaker
switch
Position the trunk correctly
Reduce the size of the trunk
Sharpen the wedge. Remove
burrs and nicks from the wedge
Contact an authorized dealer
Contact an authorized dealer
Check the oil level.
Top up if necessary.
If the problem remains, contact
an authorized dealer.
Unscrew the ventilation screw
Always tighten the ventilation
screw before transporting
Tighten the oil drainage screw
Contact an authorized dealer
15.12.2006 9:29 Uhr Seite 21
GB
21