Transport And Storage; Changing The Hydraulic Oil; Cleaning/Replacing The Oil Filter; Motor Circuit Breaker Switch - EINHELL HSP 6/104 Mode D'emploi

Anleitung HSP_6-104_SPK1:Anleitung HSP41-1_HSP51_SPK1
GB
NEVER ASK ANYONE ELSE TO HELP WHEN
TRYING TO RELEASE A TRUNK WHICH HAS
BECOME STUCK.
NEVER ATTEMPT TO RELEASE THE TRUNK
BY HITTING IT WITH A TOOL.

8. Transport and storage

Transport
1. Move the splitter as far downwards as possible
2. Switch off the wood splitter and disconnect the
mains lead
3. Move the hand guards together and secure them
with string or the like
4. Transport the wood splitter using the transport
handle in the required position (Fig. 27)
Important. The wood splitter may only be
transported in an upright position. If it is transported
in a horizontal position, the hydraulic oil must be
drained (see section 10)
Storage
Only store the wood splitter in dry rooms and in
an upright position
Move the splitter as far downwards as possible
for storage
9. Sharpening the wedge
1. Once it has been in use for some time, or as and
when necessary, you should sharpen the wedge
with a fine-toothed file and carefully remove any
burrs or flat areas on the edge.
Important!
Always disconnect the device from the power supply
before starting any maintenance work!
10. Changing the hydraulic oil (Fig. 32-
34)
The hydraulic oil should be changed after every
300 hours of operation.
1. Ensure that the splitter is fully extended.
2. Remove the oil filler screw (Fig. 32).
3. Undo the oil drain screw (Fig. 34) and place a
vessel with a capacity of at least 6 liters under
the oil drain screw.
4. Remove the oil drain screw fully by hand so that
the oil drains into the vessel.
5. When all the oil has drained, clean the oil drain
screw and screw it back into position.
20
6. Place a funnel in the opening in the oil filler
screw and pour in 2.5 – 4 liters of hydraulic oil.
7. Clean the oil dipstick at the oil filler screw and
check the oil level by inserting the dipstick into
the opening in the oil filler screw. The oil level
must be between the two marks on the oil
dipstick (Fig. 37).
Only steps 2, 6 and 7 are required to fill the wood
splitter for the first time.
Important. Dispose of the old oil in accordance with
current regulations
Recommended hydraulic oil
We recommend that you use one of the following
makes of hydraulic oil for the hydraulic cylinder:
SHELL TELLUS T22
ARAL VITAM Gf22
SP ENGERGOL HCP22
MOBIL DTE11
or an alternative of the same quality

11. Cleaning/Replacing the oil filter

Undo the screw connection in the hydraulic line (Fig.
35/ Item A) and lever out the rubber seal with a
screwdriver (Fig. 35 / Item B). Ensure that you do not
damage the seal as you remove it. The oil filter can
be removed with the hydraulic line by turning it (Fig.
36). Clean the oil filter with a cloth or replace it.
Install it in reverse order.

12. Motor circuit breaker switch

(Fig. 1 / Item 22)
If the motor is overloaded for a longer period the
motor circuit breaker switch will shut off the power
supply automatically.
This can be reset by pressing it in after waiting
approximately 1 minute. The wood splitter will then
be ready for use again.

13. Pressure control valve

(Fig. 38 / Item A)
The pressure control valve was set correctly at the
factory and must never be adjusted.
15.12.2006 9:29 Uhr Seite 20