Scope Of Use; Safety Instructions And Symbols Used; Machine Layout And Items Supplied - EINHELL BT-LS 44 Mode D'emploi

Anleitung BT_LS_44-BT_LS_55_SPK1:_
GB
Packaging
The device is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage.
Read the operating instructions carefully and
comply with them. It is important to consult these
instructions in order to acquaint yourself with the
unit, its proper use and safety regulations.
Keep this manual in a safe place, so that the
information is available at all times.
If you give the equipment to any other person,
hand over these operating instructions as well.
We cannot accept any liability for damage or
accidents which arise due to a failure to follow
these instructions.

1. Scope of use

The wood splitter is designed for splitting pieces of
wood with maximum lengths of 370 mm (BT-LS 44) /
520 mm (BT-LS 55) and diameters of 50 – 250 mm.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
2. Safety instructions and symbols
used
The applicable safety instructions and explanations
of the symbols on the device are set out in the
enclosed booklet.
14
04.09.2007 13:02 Uhr

3. Machine layout and items supplied

(Fig. 1-3)
1. Splitter
2. Trunk guidance panels
3. Trunk pusher
4. Guard handle
5. Hand guard
6. Wheels
7. Motor
8. Front support legs
9. Transportation handle
10. Main frame
11. Operating handles
12. Six screws size M6 x 16
13. One screw size M6 x 25
14. Seven washers size M6
15. Five nuts size M6
16. Two circlips size M6
4. Assembly (see Fig. 4-18)
Important! Never use the machine if it is not fully
assembled.
5. Technical data of the BT-LS 44
Voltage: 230 V 50 Hz
Power rating: 1500 W
Idle speed: 2950 rpm
Insulation class:
Protection type:
Max. splitting force:
Splitting lift: 310 mm
Splitting speed: 0,035 m/sec
Trunk holding capacity:
Diameter: 50 - 250 mm
Max. length: 370 mm
Oil quantity:
Weight:
L noise level: 78 dB(A)
pA
Seite 14
B
IP 54
4 t
2.4 l
40 kg