Honda BF40D Manuel D'utilisation page 626

5) Apply marine grease to the shift pivot installation hole in
each of the throttle arm and the shift link B.
1
6) Set the 6 mm washer on the shift pivot on each remote
control cable.
2
Set the shift side and throttle side remote control cables on
the throttle arm and the shift link B respectively, and install
the 6 mm washers and the 6 mm lock pins.
3
4
5
6
7
8
9
10
7) Connect the handle cable 14P connector and the handle
11
cable 6P connector, and install the connectors on the main
relay bracket.
12
13
14
15
16
17
8) Install the separate case, and tighten the two 6 x 28 mm
flange bolts, two 6 mm washers and the two 6 x 40 mm hex
18
bolts securely.
19
9) Perform the following adjustment.
- Throttle cable (P. 3-17)
20 - Shift cable (P. 3-20)
10) Install the engine cover (P. 4-2).
16-34
[1]
SHIFT
[2]
PIVOT (2)
THROTTLE
ARM
[8]
REMOTE
CONTROL CABLE
[7]
[SHIFT SIDE]
(MARINE
GREASE)
[1]
HANDLE CABLE
14P CONNECTOR
[3]
MAIN RELAY
BRACKET
6 x 28 (2)
[1]
SEPARATE
CASE
[2]
6 mm
WASHER (2)
[3]
6 x 40 mm
HEX BOLT (2)
626
[3]
[4]
6 mm
6 mm LOCK
WASHER (4) PIN (2)
[5]
SHIFT
LINK B
[6]
REMOTE CONTROL
CABLE [THROTTLE
SIDE]
[2] HANDLE CABLE
6P CONNECTOR