Connection & Initial Use; Radio - auna NR-620 Mode D'emploi

CONNECTION & INITIAL USE
• Connect the power cord (31) to ac outlet.
• Turn on the power (5) until the LCD display (2) with blue backlight on.
• Then switch the function selector (3) to "Tuner" function. If sound is
coming out from the speaker, it's mean the power supply is normal.
Now your system is ready to play the music.

RADIO

Manual tuning
• Select the desired band by radio band selector (12) (fm or fm-stereo).
• Tune to the required station by turning the tuning knob (14).
• Adjust volume knob (5) to the desire volume level.
FM & FM-stereo reception
• Set the radio band selector (12) at "FM" position. Programs are
received in mono mode. In particular when stereo signal are weak. It is
preferable to receive the program in mono.
• Set the radio band selector (12) at "FM-St" position for receiving stereo
programs. The fm-stereo led indicator (13) will light up to show fm
stereo program is receiving.
Note: The receiver has a built-in fm wire antenna (27) hanging at the rear
cabinet. This wire should be totally un- raveled and extended for best
reception.
EN
33