Preparation For Use - auna Verticalo SE Mode D'emploi

PREPARATION FOR USE

Unpacking and Setup
• Carefully remove the unit from the display carton and remove all
packing material from the unit.
• Unwind the AC power cord and extend it to its full length.
• Place the unit on a stable, level surface, convenient to an AC outlet, out
of a strong magnetic field.
• Connect the plug to your AC outlet.
• Remove the white plastic stylus cover from the phonograph stylus by
sliding it in the direction of the arrow.
• During this operation pay attention to the stylus,because the stylus
damage is not covered by guarantee.
• This product is designed to operate on 230 V~ 50 Hz AC only.
Attempting to operate this system from any other power source may
cause damage to the system, and such damage is not covered by your
warranty.
Protecting your furniture
This model is equipped with non-skid rubber ‚feet' to prevent the product
from moving when you operate the controls. These ‚feet' are made from
non-migrating rubber material specially formulated to avoid leaving any
marks or stains on your furniture. However certain types of oil based
furniture polishes, wood preservatives, or cleaning sprays may cause the
rubber ‚feet' to soften, and leave marks or a rubber residue on the furniture.
To prevent any damage to your furniture we strongly recommend that
you purchase small self-adhesive felt pads, available at hardware stores
and home improvement centers everywhere, and apply these pads to the
bottom of the rubber ‚feet' before you place the product on fine wooden
furniture.
Care of Cabinets
You should care for the cabinet as you would care for any piece of the
fumiture. When the cabinet becomes dusty wipe it with a soft, non-abrasive
dust cloth. If the cabinet becomes smudged with fingerprints you may use
any good quality commercial dusting and polishing spray
cleaner, however avoid spraying the plastic or metal parts of this system.
We recommend that you spray the cleaner on your dust cloth. Not directly
on the cabinet. to avoid getting any of the spray on the plastic or metal
parts.
EN
17