Using Your Coffee Machine For The First Time; Using The Coffee Machine - Delta Q ALQIMIA Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTRUCTIONS AND MODE OF USE
EN

USING YOUR COFFEE MACHINE FOR THE FIRST TIME

Check that no accessories are missing and that the equipment has
not been damaged. Then clean the interior parts taking the following
steps:
Remove the water tank simultaneously pressing its catch with
one hand and raising it with the other, moving it away.
Then place around 700 ml of water in the tank. The equipment is
endowed with two water tanks which allows usage simultaneously
or of each separately.
After filling the water tank, put it in its place and check that it has
been placed correctly.
Plug into the wall socket and connect the general on/off Button
which is located at the rear of the equipment. The indicators on
the water tank and the indicator of the espresso coffee extraction
button remain lit up.
If the access to the capsule insertion hole opens, the equipment
closes it automatically. The equipment then starts pre-heating.
If access to the capsule insertion hole is closed, the application
starts pre-heating immediately.
As soon as the indicators of the espresso coffee, coffee and tea
extraction buttons come on, this means that the pre-heating has ended.
Place a cup with capacity of over 180 ml above the cup shelf and
under the extraction nozzle.
50
Press the tea extraction button for 3 seconds to pump the water
and the indicators of the coffee and espresso coffee extraction
buttons go out, with the indicator of the tea extraction button
flashing.
The extraction nozzle starts expelling water and the flow stops
automatically after obtaining around 180 ml of water.
Turn the main switch off and remove the plug from the socket.
Empty the water tank and carefully clean all the detachable parts
with water.
Note: When pressing the espresso coffee, coffee and tea
extraction buttons, the machine may cause a pumping sound.
This is normal; the sound indicates that the water is being
pumped to prepare coffee or tea.

USING THE COFFEE MACHINE

Extracting an espresso coffee (35 cc)
Remove the water tank by pressing its catch and raising it to
move it away. Fill the detachable water tank without exceeding
the MAX mark inscribed thereon.
Note: The maximum capacity of two water tanks is 1400 ml.
The water tank must be full up to the maximum level, so as
to reduce the frequency of this operation.
Then put the water tank back in its place, checking that it has
been correctly placed.
Connect the machine to the electrical current and press the general
on/off button which is located at the rear of the equipment. The
water tank indicators and the indicator of the espresso coffee
extraction button are lit up. The equipment starts pre-heating.
Once the desired temperature has been attained, the indicators
of the espresso coffee, coffee and tea extraction buttons light up.
Place an espresso coffee cup on top of the cup shelf and under
the extraction nozzle.
Press the espresso coffee extraction button once and the access
to the capsule insertion hole opens. The indicators of the coffee
and tea extraction buttons go out and the indicator of the espresso
ALQIMIA
coffee extraction button flashes.
Insert just one coffee capsule in the access to the capsule insertion
hole.
Press the espresso coffee extraction button a second time.
Access to the capsule insertion hole closes automatically.
The equipment prepares the capsule and the indicator of the
espresso coffee extraction button flashes.
After preparing the quantity of coffee selected, the equipment
stops and lets the used capsule fall automatically into the capsule
collection tray.
During the preparation of coffee, the espresso coffee extraction
button may be pressed for the third time in order to stop the
operation.
During the preparation of coffee, if there is any warning of a lack
of water, blockage or no capsule collection tray (the details are
indicated in the TROUBLE-SHOOTING section), the equipment
stops and, to resolve the problem, press the espresso coffee
extraction button to close and eject the used capsule and load
the next capsule.
Once the desired coffee has been obtained, the equipment stops
automatically and returns to the "function available for use" mode
51

Publicité

Table des Matières
loading

Table des Matières