Charging; Power Switch - Sony BC-L500 Mode D'emploi

g Plug holder receptacle
Secure the AC power cord with the supplied plug holder as
illustrated below so that the cord will not come loose from
the charger.
To remove the AC power cord
h POWER switch
Press the ? side of this switch to turn on the battery charger.
When the charger is turned on, the POWER indicator
lights up and the charging starts when the battery packs are
inserted.
18

Charging

Plug holder
(supplied)
Charging
1
Connect the AC power cord to the -AC IN
connector, then connect the other end of the cord to an
AC power outlet.
2
Press the ? side of the POWER switch to turn on the
battery charger.
3
Insert the battery pack.
Insert the battery pack into the slot as illustrated
below. When battery packs are inserted into all slots,
you can charge four battery packs simultaneously.
Insert in the direction of the
arrow until you hear a click.
When the width of the battery pack is narrower than
the slot, be sure to match the center line of the battery
pack with that of the slot.
During charging, the charge indicator above the slot
flashes according to the charging process. When the
charge indicator lights up in green, charging is
completed.
When charging is completed
Remove the battery pack from the slot as illustrated below,
then press the a side of the POWER switch to turn off the
battery charger.
Press the release button
while supporting the battery
pack by hand, then pull out
the battery pack.
Battery pack