Introduction; General; Liability; Manual - Husqvarna HTC 950 RX Manuel De L'opérateur

Introduction

1 Introduction
1.1

General

HTC 950 RX (R = Radio control, X = Four grinding discs) is a grinder that can be used
to grind, strip, clean and polish concrete, natural stone and terrazzo floors. The
machine's area of application depends on the choice of tool. You can easily mount and
replace the tool, thanks to the EZchange patented tool system.
The radio control means the operator is not affected by any vibrations from the
machine. Moreover, the grinding work is more effective since, for instance, emptying
the dust extractor and handling the cables can be done while the machine is grinding.
Read the manual carefully, so you are totally familiar with the machine before you start
to use it. Contact your local retailer for further information. For contact information, see
Contact Information at the start of the manual.
1.2

Liability

Even though every effort has been made to make this manual as complete and accurate
as possible, we bear no responsibility for incorrect or missing information. HTC
reserves the right to change descriptions in this manual without giving prior notice.
This manual is protected by the Copyright Act and no part of it may be copied or used
in any other way without the written approval of HTC.
1.3

Manual

In addition to the general functions, this manual deals with the areas of application and
the maintenance of the grinder.
1.3.1

Safety explanations - explanation of symbols

A number of symbols are used in the manual to highlight the most important sections,
see below. In order to avoid both personal injury and material damage as far as possible,
it is extremely important to read and understand the text next to these symbols
particularly carefully. There are also other symbols indicating practical tips. These are to
help you use the machine in the easiest and most effective way.
The following symbols are used in the document to indicate where special attention is
needed.
2
HTC 950 RX
5.0